Week 12 (June 17)

This is what i'm doing in workshop today. i have take some photo to proof what i doing with my partner and i will step by step explain it.

First, my partner and i do a calculation for drilling a hole on master cylinder and clutch pedal.

After finished our calculation, we followed roman went to workshop start our project. When we reached the workshop, roman prepare some appliances ( electrical drill and others)

I start to explain how we do our project.

We using steel utility workshop to holding and stable the master cylinder when we drilling the hole on it.

Before we are start drilling a hole on the master cylinder, we should make some drill marking to drill correct position.

My partner helped roman hold the master cylinder to make it more stable. Otherwise drilling, the master cylinder will shake.

We tried to drill a hole and we swept the dust by duster brush. And now we start drill second hole.

Drilling second hole. Roman told my partner didn't use hand to hold the master cylinder and pass the  hammer to my partner try pressing it 

Drilled the hole had been done. Those screw obstruction the boosters put inside that hole, so now we are cutting project.

After cutting down, we make 2 marking to drill hole in there and we start continue drilling.

We have also made a hole in the top of the clutch pedal to lock the clutch on the wood.

 Do not swing on the wood.

Ta daa. This is what we done in working.